Ohlins Rear Shock Bump Stop - Stiff
£13.80
1 in stock
Part Number
163-12
Foam rubber bump stop as found on the rear suspension shock absorber unit, used to prevent harsh bottoming out.
ID: mm (To fit 14mm Shaft)
OD: mm
Height: mm
Stiffer rubber
Can be used on the Beta Rev 3 Paioli shock, requires modifying to fit, the rubber needs shortening by 5mm and then use a die grinder with a carbide burr to make the recess to fit over the raised part of the end eye.
You can remove the end eye without losing any oil. Just be careful with the needle and adjuster screw because it’s all a bit delicate.
ID: mm (To fit 14mm Shaft)
OD: mm
Height: mm
Stiffer rubber
Can be used on the Beta Rev 3 Paioli shock, requires modifying to fit, the rubber needs shortening by 5mm and then use a die grinder with a carbide burr to make the recess to fit over the raised part of the end eye.
You can remove the end eye without losing any oil. Just be careful with the needle and adjuster screw because it’s all a bit delicate.
Fitting requires the spring to be removed and the top of the shock to be unscrewed, to do this the shaft on the shock has to be held securely but without damaging the surface so a special tool will have to be made, we recommend drilling a hole the same size as the shaft in a piece of aluminium and cutting it in half so the shaft can be clamped in the vice.
| Manufacturer | Ohlins |
|---|
Write Your Own Review